Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateFast, Reliable Garage Door Repair Across White City
If your door has stopped moving, you’re in the right place. Garage door repair in White City typically runs $150 – $600 depending on what’s failed, and most spring and cable jobs are finished the same day. We work on the door and opener you already have, whether that’s a 1970s wood sectional behind a carport or a newer LiftMaster rig on a fixed-up bungalow. White City’s older, unincorporated housing stock fails differently than the newer subdivisions south of here, and we know the difference. Call (833) 847-0310. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.

Why White City Homeowners Call Tundra Garage Door Repair for Garage Door Repair
Tundra Garage Door Repair handles the full cycle, from a snapped torsion spring on an aging Amarr door to a dead opener to a full replacement, and we service all eight of the most widely installed residential door and opener brands. That matters in White City, where a lot of doors were installed decades ago and the “right” part isn’t always the obvious one.
We keep our response tight to White City specifically, because a door stuck open on a humid afternoon is a security problem before it’s a convenience one. And our technicians have up to 12 years of experience, so a legacy Craftsman or Genie opener that’s stripped a gear gets diagnosed correctly instead of being blamed on the springs.
You’ll also get a written price before we start. No surprise invoice once the door is off its tracks. That’s the deal, every time.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Garage Door Cable Repair in White City
Garage Door Cable Repair in White City is one of the most common jobs we run, because salt-laden coastal air eats through the steel cables on older doors faster than most homeowners expect. A frayed or snapped cable usually announces itself with a loud pop and a door that hangs crooked or won’t lift at all. When one cable goes, the other is usually close behind, and the drums and springs take the strain. We inspect both sides, replace the worn cables, and reset the tension so the door tracks level again. Typical cable repair here runs $130 – $250, with the written estimate setting the final price.
What a Cable Replacement Involves
The spring tension has to come off safely before any cable is touched, which is why this isn’t a homeowner job. We release the tension, swap the cables and any worn drums, then re-tension and cycle-test the door. If the springs are already corroded, we’ll tell you straight rather than replace the cable twice.
Signs Your Cables Are Failing
Look for a door that lifts unevenly, a visible kink or fray near the drum, or a gap in the cable windings. Rust staining on the cable is the early warning sign most people miss on White City doors.
Garage Door Spring Repair in White City
Garage Door Spring Repair in White City often means dealing with original torsion springs on mid-century doors that have cycled for decades in heat and humidity, and those springs can snap without warning. When a spring lets go, the door feels impossibly heavy and the opener strains or quits. We test the door balance first, then either re-tension or replace. A single spring runs $180 – $340, and since a matched pair is usually replaced together, count on roughly twice that for both. The written estimate sets the final price.
Repair or Replace the Whole Door?
If the panels, tracks and hardware are sound, new springs and cables bring the door back to safe operation. If the door is a wood or early steel tilt-up with undersized hardware and rusted tracks, a full replacement in the $700 – $2200 range often makes more sense than pouring money into a door that’s already past its service life.
Why Corrosion Kills Springs Here
South Florida’s humidity and salt air pit the spring wire, and that pitting becomes a fatigue point. A spring that would last years inland can fail early on a coastal White City lot.

Trusted Brands We Service in White City
We work on the brand you already own. That means Raynor and LiftMaster systems, along with Chamberlain, Genie, Clopay, Amarr, Wayne Dalton and Craftsman. Most White City homeowners already have one of these installed, so there’s no guesswork about parts or compatibility. We don’t claim to stock parts in a truck or warehouse; we diagnose what’s wrong, source what’s needed, and get you a written price before work starts. Whether it’s a legacy opener with a corroded logic board or a newer Wi-Fi-connected LiftMaster unit, we know the electronics as well as the hardware. One call covers repair, opener work or a full installation.
Common Garage Door Repair Problems We See in White City Homes
- Snapped torsion springs on mid-century doors. These original springs fail from corrosion and fatigue after decades of daily cycles, and they often go without warning. It’s a loud, unnerving failure that leaves the door immovable.
- Rusted tracks and hinges on older steel doors. Salt air and humidity pit the steel, causing binding and misalignment that wears the cables and overloads the opener. Left alone, a sticky track turns into a snapped cable.
- Legacy openers from the 1980s and 90s giving out. Craftsman, Genie and LiftMaster units from that era fail on corroded logic boards or stripped gears, and homeowners often blame the springs when the opener is the real culprit.
- Storm and wind damage on aging doors. Near-daily summer thunderstorms and hurricane-season gusts work loose the hardware on doors that were never built for reinforced wind-rated service, leaving panels misaligned or tracks bent.
See the difference
Before
After
Before
After
Before
AfterPricing for Garage Door Repair in White City, FL
We quote per job, and the written estimate sets the final price before any work begins. These are typical estimated ranges for White City:
| Service | Typical Estimated Range |
|---|---|
| Spring Repair (one spring) | $180 – $340 |
| Cable Repair | $130 – $250 |
| Garage Door Repair (overall) | $150 – $600 |
What moves the number is the condition of the surrounding hardware: rusted tracks, worn drums, an opener that’s also failing, or a door old enough that replacement beats repair. A matched pair of springs costs about twice the single-spring range, since they’re usually changed together. Estimates are free, and the written price is agreed before we lift a wrench.
We Also Serve Cities Near White City
White City sits just south of Fort Pierce, and we cover the surrounding communities too, including Indian River Estates, Fort Pierce South, River Park and Port St. Lucie. If you’re nearby and your door is stuck, the same written-estimate approach applies. Learn more about our garage door repair service and how we handle jobs across the White City area.
Serving White City, FL – Our Local Coverage Area
We serve White City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs About Garage Door Repair in White City
It depends on the panels, tracks and hardware. If they’re sound, new springs and cables in the $180 – $340 range for a single spring will bring it back to safe operation. If the wood is warped, the hardware is undersized and rusted, or the door is a one-piece tilt-up past its service life, replacement often makes more sense. We’ll give you both numbers in writing and let you decide. Call (833) 847-0310 for a free estimate.
If the opener hums or strains but the door barely moves, that’s usually a spring that’s lost tension, not the opener. If the door is balanced and moves by hand but the opener won’t run, the fault is in the opener. That’s why we test balance first. Older Craftsman and Genie units complicate it, since a stripped gear can mimic a spring failure. Call (833) 847-0310 and we’ll sort out which it is.
Cable repair typically runs $130 – $250, and track realignment runs $120 – $240. Rusted tracks often take cables with them, so we inspect both and quote the full job up front. The written estimate sets the final price. Call (833) 847-0310 for a free estimate.
Often yes. Salt air pits standard spring wire, so a higher-cycle spring holds up longer before corrosion becomes a fatigue point. It costs more than the $180 – $340 single-spring range, but fewer replacements over time can offset it. We’ll explain the tradeoff in person. Call (833) 847-0310 for a free estimate.
We service both. If it’s a corroded logic board or stripped gear, a repair in the $120 – $320 opener-repair range often keeps it running. If the unit is a 1980s – 90s model with no safe way to add modern safety sensors, replacement in the $250 – $550 installation range is the safer call. We’ll tell you which it is. Call (833) 847-0310 for a free estimate.
Get Your White City Garage Door Fixed
If your door is stuck, crooked or straining, don’t force it. Call (833) 847-0310 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. One call covers the spring, the cable, the opener or a full replacement.
Written by the team at Tundra Garage Door Repair.